Crescent Moon Cycles

New & Re-Cycled Old-Wing Parts

 fanchier@charter.net

We can get New OEM Parts from Honda for you too!!

(810)-412-6351 10AM - 6PM EST

• New Mercury free design!
• Precise four channel vacuum indicator designed specifically for intake synchronization of engines with multiple carburetors or throttle bodies.

$90.50    Item # 11-103

This is not your ordinary gauge set. Each 2" gauge features 0-76cm/hg readings, shut off valve and all hardware is high grade chrome finish instead of brass for longer life, higher corrosion resistance and better flow accuracy. Air flow control is handled by needle and seat valves instead of knobs.This helps to resist the dial indicator "bounce" associated with many other lower quality gauges. Set comes complete with a durable aluminum storage case. Included are 4pcs of each of the following: 950mm rubber hose set, 52mm and 122mm long extension tubes, 40mm long cone type connectors for ext tubes, 53mm M6 x .75, 160mm M5 x .8 connectors

$165    Item # 708

A 14 piece wire set with spiral knurling for cleaning popular size jets and carb body holes/ passages.

$6.80    Item # 11-065

Carb Float Level Gauge

For measuring float level height between the float and carburetor gasket surface

Adjustable to fit most carburetors
 

$43   Item # 11-016

• Durable translucent polyethylene tank
• Kit includes screw-on cap, hanger, 4 ft. of 1/4" neoprene fuel line and petcock with 1/4" ends
• Provides fuel after your gas tank has been removed during multiple carburetor synchronization

$44.50     Item # 541-707 

• 2-pc. tool simplifies and speeds up carburetor adjustments
• Approx. 11"L steel tube has 8mm socket on one end and a breaker bar on the other to loosen and hold nut
• For all multi-carb Honda, Kawasaki, Suzuki and Yamaha cycles with top-adjustable Mikuni and Kehin carbs

• Insert screwdriver into the tube to reach adjustment screw and make adjustments. Hold screw in place with screwdriver while tightening down the hold-nut.

$17.50    Item # 11-062

90-Degree 1/4” Hex Driver Set

• This gear driven, 1/4” hex driver set is made of high grade aluminum and stainless steel. Strongest tool of it’s type on the market. Designed for use on hard-to-reach pilot air screws on inline fours. Can be used with any 1/4” or 6mm hex bits.

$76.25    Item # 11-063

• Retractable flat-slot blade tip
• Black finished alloy steel housing with sure-grip knurled end
• Fits into hard-to-reach areas to allow easy adjustments of the pilot screws on the 2 center carburetors of 4-carburetor cycles

• Tool features 1" angled screwdriver head with self-alignment hood (simplifies positioning around pilot screw head) plus a retractable tip. With tool in position, simply push handle to engage tip and then rotate to make adjustment. Approx. 18"L.

$23.75   Item # 11-064